MachPanel Knowledgebase

HOW TO:Enable Authorize.Net CIM in MachPanel

Mudesira Munir


This article provides summary on how to Enable Authorize.Net CIM in MachPanel.

Applies To
This article applies to MachPanel build v6.0 and above
Enable Authorize.Net CIM in MachPanel:

    Automated routine is added in provisioning service to create existing billing profiles (credit cards) on gateway. Existing profiles will be auto created or even if user edits any card, it will create profile if not exists on gateway. You just need to configure CIM Payment gateway for all companies (Provider/Resellers).

    • The Authorize.Net AIM method was being used when PCI mode is disabled under "Billing Settings". Now this method is disabled and Authorize.Net CIM will be used instead. First of all configure Authorize.Net CIM enable PCI compliance mode from path: Home > System Configuration > Billing Configuration > General Billing under Billing Settings as shown below:
    • Configure Authorize.Net CIM from Home > System Configuration > Providers > Payment Gateways

    • Now edit all "payment groups" to use Authorize.Net CIM method from following path: Home > System Configuration > Billing Configuration > Payment Groups

    Type: HOW TO
    Level: Intermediate
    Last Modified: Last Month
    Last Modified By: mudesira.munir
    Article not rated yet.
    Article has been viewed 8.8K times.
    Also In This Category